adc_poll_10bit.c File Reference

#include "fw_hal.h"

Go to the source code of this file.

Functions
void	main (void)

Function Documentation

main()

void main

(

void

)

STC8H3K64S2 AGrnd -> GND AVcc -> VCC AVref -> VCC Vcc -> VCC Gnd -> GND ADC1 -> Test voltage

STC8H1K08 AVref -> VCC Vcc -> VCC Gnd -> GND ADC1 -> Test voltage

Definition at line 32 of file adc_poll_10bit.c.

{
    uint16_t res;
    SYS_SetClock();
    // For debug print
    UART1_Config8bitUart(UART1_BaudSource_Timer2, HAL_State_ON, 115200);
    // Set ADC1(GPIO P1.1) HIP
    GPIO_P1_SetMode(GPIO_Pin_1, GPIO_Mode_Input_HIP);
    // Channel: ADC1
    ADC_SetChannel(0x01);
    // ADC Clock = SYSCLK / 2 / (1+1) = SYSCLK / 4
    ADC_SetClockPrescaler(0x01);
    // Right alignment, high 2-bit/4-bit in ADC_RES, low 8-bit in ADC_RESL
    ADC_SetResultAlignmentRight();
    // Turn on ADC power
    ADC_SetPowerState(HAL_State_ON);
 
    while(1)
    {
        ADC_Start();
        NOP();
        NOP();
        while (!ADC_SamplingFinished());
        ADC_ClearInterrupt();
        /*
        res = ADC_RESL;
        res |= (ADC_RES & 0x0F) << 8;
        */
        UART1_TxHex(ADC_RES);
        UART1_TxHex(ADC_RESL);
        UART1_TxString("\r\n");
        SYS_Delay(100);
    }
}